Radiator Flush for the Car Cooling System
Flamingo Radiator Flush is a cleaning solution for your car’s cooling system. It is used before refilling with new coolant to clean and flush the internal components of the system.
Add the product to the cooling system together with clean water, allow it to circulate for the specified time, and then drain it completely. Afterwards, flush the system with clean water before refilling with the correct type and amount of coolant. This product is not coolant, antifreeze, or an additive intended to remain permanently in the system.
Dosage
- 1 container of 354 ml is sufficient for a cooling system with a capacity of up to 10 litres.
- For systems with a capacity of 10–20 litres, 2 containers are required.
Directions for use
- Make sure the engine is switched off and the cooling system is completely cool.
- Drain the existing coolant completely from the system.
- Pour the product into the cooling system and top up with clean water.
- Let the engine idle, or drive the car for 1–2 hours.
- Switch off the engine, allow the system to cool, and drain the liquid completely.
- Refill the system with clean water.
- Let the engine idle, or drive the car for 10–20 minutes.
- Allow the system to cool and drain the water.
- Flush the system thoroughly and then refill with suitable coolant according to the vehicle manufacturer’s instructions.
Important to know
Do not open the radiator cap or expansion tank when the engine is hot or the system is under pressure. Wear protective gloves and eye protection. For professional use only.
